PPL/IR Europe
The Home of European GA IFR Pilots
 
 

Carbon Monoxide Poisoning

The FAA have issued guidance (36 KB) on the use of Carbon Monoxide detectors.

 

FAA Aviation Safety  
SPECIAL AIRWORTHINESS INFORMATION BULLETIN
  
 SAIB: CE-10-19 R1
SUBJ: Engine Exhaust and Carbon Monoxide Detectors
Date: March 17, 2010

This is information only. Recommendations aren’t mandatory.

 

Introduction

This Special Airworthiness Information Bulletin (SAIB) advises the owners and operators of general aviation (GA) aircraft of an airworthiness concern, specifically the need to inspect properly and maintain the exhaust system to prevent carbon monoxide leakage into the cabin and to install a commercially available carbon monoxide detector in the cabin. This revision adds the Federal Aviation Administration (FAA) Technical Center library website and revises the recommendation section.

At this time, this airworthiness concern is not considered an unsafe condition that would warrant an airworthiness directive action under Title 14 of the Code of Federal Regulations (14 CFR), part 39.

Background

This SAIB is in response to a National Transportation Safety Board (NTSB) investigation of an accident on December 17, 2000, where a Beech Model BE-23 aircraft impacted terrain killing the commercial-rated pilot, the sole occupant of the airplane. The NTSB determined the probable cause of the accident was in part “the pilot’s incapacitation due to carbon monoxide (CO) and a fractured muffler.”

The FAA tasked Wichita State University to conduct research that focuses on carbon monoxide safety issues as they apply to general aviation products. A technical report titled “Detection and prevention of carbon monoxide exposure in General Aviation Aircraft, Document No. DOT/FAA/AR-09/49, dated October 2009” was published, and is available from the National Technical Information Services using the contact information noted below, and is also available electronically at http://www.tc.faa.gov/its/worldpac/techrpt/ar0949.pdf . The report shows that 43 commercially available CO detectors, sampled from each of the five sensor technology types (biometric, electrochemical, spot, infrared, and semiconductor) were surveyed to determine the most appropriate sensor technology. The electrochemical sensor-based CO detectors were found to be most suitable for use in the GA environment. Limited field testing using portable electrochemical CO detectors was conducted in two GA aircraft models to determine the best location for a CO detector. Based on the analyses of collected CO data, the instrument panel appeared to be the best location for the placement of CO detectors. The report notes that, to increase the probability of being able to detect at least 50 parts per million (PPM) anywhere in the cabin, the CO detector should be set at a lower alarm threshold of 35 PPM. Performance parameters and specifications of various CO detectors (available on the market) were compiled into a database as shown in Tables B-2 through B-5 of the technical report.

Recommendation

The FAA recommends that you do the following:

  1. Consider the information in the technical report, and use a CO detector while operating your aircraft.
  2. To detect leakage of gases into the cabin due to cracks in the exhaust system, conduct engine run up tests with cabin heat on and check for CO in the cabin with a hand-held CO detector during 100 hour and annual inspections.
  3. Continue to inspect the complete engine exhaust system during 100 hour/annual inspections and at inspection intervals recommended by the aircraft and engine manufacturers in accordance with their applicable maintenance manual instructions.

For Further Information Contact

Sarjapur Nagarajan, Aerospace Engineer, FAA Small Airplane Directorate, 901 Locust, Kansas City, Room 301, Missouri 64106; phone: (816) 329-4145; fax: (816) 329-4090; email: This email address is being protected from spam bots, you need Javascript enabled to view it '; document.write( '' ); document.write( addy_text88252 ); document.write( '<\/a>' ); //-->\n This email address is being protected from spam bots, you need Javascript enabled to view it

For Related Information on the Technical Report, Contact:

U.S. Department of Commerce
National Technical Information Services (NTIS)
Alexandria, Virginia 22312
(703) 605-6000 or 1-800-553-6847

 
< Prev   Next >
 
Joining PPL/IR Europe
 
 
Lobbying | Getting a Rating | Events